Fencing Components

Tension Band - is used in conjunction with a tension bar to attach the chainlink fabric to the terminal post.

Brace Band - attaches a rail end to the terminal post in order to hold the top rail in place.

Rail End - is used in conjunction with a brace band to hold the end of a top rail, which is the pipe running along the top of a chainlink fence.

Line Post Cap - covers the top of a line post and holds the top rail in place by passing the pipe through the eye loop.

Terminal Post Cap - covers the top of a terminal post, which can be either a corner post, end post or gate post.

Tension Bar - is used in conjunction with a tension band to attach the chainlink fabric to the terminal post. The tension bar is passed through the last vertical row of diamonds in the chainlink fabric.

Turnbuckle - a device with two eye bolts that is used to tighten a strand of wire such as the bottom wire that runs along the bottom of a chainlink fence.

Bottom Wire Clip - also called a pig ring, it clips the bottom wire to the bottom of the chainlink fence.

Post Collar - clamps around a gate post and holds the hinge bolt in place.

Frame Collar - clamps around the gate frame and sits on a hinge bolt allowing the gate to swing open or closed.

Hinge Bolt - bolts to the post collar and holds the frame collar in place.

Finger Latch - clamps around a residential gate frame and latches to a latch catch that is clamped to a gate post.

Latch Catch - clamps around a gate post and holds the finger latch in place when the gate is closed.

Wall Latch - similar to a latch catch that is attached to a plate that can be mounted to a wall.

Spring Closure - is a hinge bolt with an additional spring assembly that automatically closes an open gate.

Corner Barbed Wire Arm - covers the top of a corner terminal post and holds the strands of barbed wire in place at a 45 degree angle above the toprail.

Barbed Wire Arm 45° - covers the top of a line post and holds the strands of barbed wire in place at a 45 degree angle above the toprail.

Barbed Wire Arm Vertical - covers the top of a line post and holds the strands of barbed wire in place at a 90 degree angle above the toprail.

Barbed Wire - consists of a double strand of wire with sharp points of wire spaced along the strand.

Boulevard Clamp - clamps to the bottom of an industrial line post and is used to hold a bottom rail in place.

Eyebolt - is attached to a terminal post with a bracket and brace band to tighten the strands of barbed wire.

Sleeve - a short metal tube that is used to join two pieces of top rail.

Industrial Post Collar - clamps around a gate post and holds the hinge bolt in place.

Industrial Frame Collar - clamps around the gate frame and sits on a hinge bolt allowing the gate to swing open or closed.

Industrial Drop Latch - clamps around the gate frame and latches to a latch catch that is clamped to a gate post (single gate) or gate frame (double gate).

Industrial Latch Catch - clamps around a gate post (single gate) or gate frame (double gate) and holds the industrial drop latch in place when the gate is closed.

Industrial Hinge Bolt - bolts to the post collar and holds the frame collar in place.

Industrial Cane Bolt - is attached to one panel of an industrial gate. When the gate is closed, the cane bolt is dropped to the ground with the end part sitting in the center rest

Industrial Center Rest - is cemented in the ground in the middle of a industrial double gate. It holds the cane bolt in place to prevent a gate panel from swinging open.

Hold Open Chain - is used to hold open a gate panel against the fence.